I've been trying to put the Sailors on the caps but it's hard. Any suggestions to make it easier and stop making my hands bleed? :lol:

water or rubbing alcohol? if that doesnt work, then maybe a small amount of soapy water, then dry it off?

Put the Sailor grip on the pen cap first .... next push the Dr. Grip tip in diaganol so you get like half of it in easy ...

then push the other half in and get it to slip into the sailor grip ..........
after that just keep rocking it side to side and pushing till its where you want it ...

it gets easier after you've done a few :spin:

Soon Joshua will pop in and tell you to lift some weights for a while, and then get the grips onto the caps by flexing your arms :)

But really, you just need to press / pull hard to get them over... there's no secret trick or anything :P

i think it was that hard to put them on but you might try putting the grips in hot water and then putting them on

Stretch the grips out by opening scissors or needlenose pliers inside of them. Sailor gels probably won't break but be careful all you dorks out there. You're a lot more likely to just cut them wrong than snap them this way, but still take care. Then just lick the cap & they should slide on easily.

just push.

some grips take a while to get on if they're brand new.

What I did was I got this pen that was a little smaller than the KT caps. So I put the girps on that and waited a while. The grip got wider so it was easy to put the grips on the KT. :banana: